I overheard this conversation between a local transfer engine talking to a bridge operator on a branch line very close by. "Engine 303 calling bridge 728, come in," the engineer called on the radio. "Bridge," replied the operator. Engine 303 answered, "Ya, engine 303 is on the approach to the bridge and we have a red signal." The bridge operator replied, "Engine 303 come down to the red signal and stop, then give me a call." This is required by the rule book.Īfter arriving at the signal engine 303 called, "Bridge, this is engine 303, we are stopped at the red signal." The bridge operator then instructed, "Engine 303 you have permission passed the red absolute signal displaying stop, check the route as you go." At this point engine 303 is supposed to repeat these instructions so there can be no misunderstandings. I'm listening for engine 303 to reply but he isn't saying anything. Then after what seemed like an eternity but was less then a minute, a voice from engine 303 came on the radio and said, "WOULD IT BE BETTER IF THE BRIDGE WAS DOWN?" All the trainmasters and dispatchers are listening on the radio as well, so if this guy doesn't repeat the instructions he is in for a butt chewing. So, in effect, the bridge operator flagged engine 303 by radio off into the canal but the 303 didn't bite. You couldn't hear them but you knew phones were ringing somewhere and a trainmaster was hustled out to the bridge to sniff the operator to see if he was incapacitated in some manner. This story was related to me by a retired railroad conductor. We were following another train that was in the block ahead but because of track curvature we couldn't see his last car. We had red blocks but by rule we can follow this train at "restricted speed," meaning that we operate at 15 mph or less and stop within half or our range of vision when we do see the train ahead. We were chatting and moving real slow so we weren't paying enough attention ahead. Our train came around a curve and the last car of the train ahead was sitting right there. My engineer hit the emergency valve but it was too late. We hit the rear end of the train ahead at about 8 mph. There was no caboose because we were using the flashing RED's or rear end devices back then. Luckily no cars derailed and there was no other damage. However, our engine coupled perfectly onto the last car in the other train. When this happens our train stops and the other train is shoved ahead a few feet. It puts the couplers in a stretched position. When they are stretched tight you cannot pull the pin to separate the two couplers. We cannot move our train at all until the engine pumps the air back up in our entire train. In the mean time, I hear the other train get a high ball from his conductor. There is nothing we can do but wait for the jolt from the other train leaving. The jolt wasn't much but we did hear the other train go into "emergency" as he lost his air. He called the dispatcher and reported that he would have to walk his train to fix the air leak. We got the air pumped up on our train and tippy toed back about two hundred feet from rear of the train we hit. I called the dispatcher and said, "If you want me to I'll step out and see if I can see anything on the other train." (Our work rules clearly stated I didn't have to and the dispatcher could not force me to). He was delighted and said, "Yes, please do, that would be a big help." So I started walking and made a discovery. I called the dispatcher and said, "I found it, 15 cars from the rear end there is a drawbar pulled out." This is major damage but when the leaving train could not move because we were tied on, it found the weakest link.
0 Comments
Leave a Reply. |